Chevy Check Engine Light Flashing then Stops – (Causes & Fixes)

Traffic lights are the controlling units we all refer to when driving. It protects both pedestrians and drivers from accidents caused by wrong timing. Similarly, every car has been manufactured with signals and warning lights for the safety of the car itself and the passengers. You may have encountered oil pressure indicators, tire pressure warnings, or battery alerts while driving. If you are puzzled by an instance where Chevy check engine light flashing then stops, you are most welcome here. We are going to give you a hand in solving the question that gives you a headache. 

What Does your Check Engine Light Mean?

The check engine light indicates a fault in the engine system or in the gear system and chains. There are many reasons that turn on this light. According to the way of illuminating, the drivers can get a clue on the fault. 

It is recommended to drive only a short distance when you see your check engine lights are on. Because it has the potential risk of increasing the damage, which results in a huge sum for the repair, therefore, try not to travel much and high speed when your check engine lights are flashing. The best thing you can do is to stop at a mechanic. After the inspections, he will find the cause and treat it accordingly. 

What Causes the Check Engine Light to Come On?

There are many possible answers to this question. Sometimes the reason may be as simple as a loosely fitted gas cap and a wrongly installed alarm system. In some cases, the reason may be worse than that and will make you costly repairs like malfunctioning the catalytic converter and faulty spark plug wires. If you need to replace the catalytic converter, it will cost you around $200, and spark plug wire replacement will be priced at nearly $50. 

If the matter is with the ignition coil of the spark plugs, you will be announced it with the engine lights. This serious issue could suddenly shut you off in the middle of a highway. Now you should clearly know why we warned you to avoid distance travelling when the check engine light is on. You will need a special tool to recognise which cylinder has the damaged or worn-out wire. A spark plug wire repair will be around $50. A spark plug will be less costly at $10 or $20, but if you need to replace the ignition coil, it will be pricier, probably around $50. 

The MAF sensor is the responsible unit for controlling the air that enters the engine to be mixed with the fuel. When this sensor malfunctions, you will notice the engine lights turned on. As the same when the oxygen sensor is not working properly, it will be observed with engine lights. 

Why Chevy Check Engine Light Flashing then Stops? 

There are many patterns of check engine light indications. If your Chevy’s engine light appears and then stops after some time, it is not an issue that you need to call for a towing vehicle. But it also has some seriousness. You can ride at a low speed and go to your destination. But make sure you search for a scan to detect the problem with the help of a technician. 

Some probable cases are misfiring in the engine, malfunctioning in the catalytic converter and damaged injectors. When there is an emission problem, it is also indicated by a check engine light that goes off slowly.

Together with the flashing, if you smell gasoline inside your car and see a decrement in fuel efficiency, it should be an emission problem. When there is a bad odour coming from the discharging gas, and you feel difficulty increasing the speed, there is a high chance of a clogged, damaged, or worn catalytic converter.  

When the engine skips, and there is an identical increment and colour change in the exhaust gas while the check engine light is on, we can assume that one of the engine sensors is in danger.

Do you remember a recent idling of your engine when the engine light is on? If so, the reason may be a failure in injectors. 

Why is Chevy Check Engine Light on Constantly?

If the check engine light is on and does not go off after a few seconds, then it is not a serious case often. Check whether your gas cap is fixed properly. Tighten the gas cap and see whether the light is still on. If so, there may be another reason, like loosened connective wires, electrical issues, and low brake fluid levels. 

When there is a noticeable brightness change in the headlights and a reluctance to start the engine with a flashing engine light, it says that your electrical wiring needs an urgent inspection. When the gears are slippery with flashing engine lights, you must check whether fluid levels are lower than average. 

If you are clueless about finding the problem, do not hesitate to search for a mechanic in your next destination because untreated issues have the potential to create permanent and severe damage. 

Why Does Chevy Check Engine Light Flash Rapidly?

When the check engine light of your Chevy is flashing rapidly without stopping, it is the worst incident. There may be severe engine failure if you continue to ride afterwards. Therefore, we highly recommend stopping your car by the side and calling for help. It would be better if you could get the help of a tow truck to carry the vehicle to an automobile repair shop. 

How to Fix a Flashing Check Engine Light?

First, you must go for a service provider to identify the issue with a diagnostic scanner. The code it creates will find the exact place to be repaired. You must get the help of a skilled technician here. 

When the check engine light is lit up in Yellow, it is usually a minor case. But make sure you go for a mechanic soon. When the light is Red, you must immediately stop the car and call for help. 

You May Also Like

• Check Gages Meaning On A Car – Full Explanation
• Oil on Camshaft Position Sensor; What to do?